hyBoard

hyBoard

This is the board for E1 processors. The executable code of a program can either be downloaded to the boards or directly programmed into the on-board Flash EPROM. The application program is then executed on the development board under control of a debug monitor, following the commands of the hyDEBUG sourcelevel debugger. Your own prototype hardware can easily be adapted using the I/O expansion connectors on the board. The development board can either be operated via the AT-bus for rapid data transfer, or outside the PC, linked to the serial interface using the hyICE. The development board is equipped with up to 8 MB DRAM or EDO RAM, up to 512 KB fast SRAM and up to 512 KB Flash-EPROM containing the debug monitor firmware. In many cases, you can design your special application just as a subsystem of this development board. USB and Ethernet ports are available for the application.

hyNet XS

hyNet S PCI

hyNET XS, hyNET S PCI

These are the boards for the hyNET series of Hyperstone processors. There are various interface configurations possible. Some interfaces are always present others depending on configuration.

• hyNet-XS: stand alone system for hyNet XS processor
• hyNet-S PCI: PCI card for hyNet S processor
• Memory up to: 2 * 128MB SDRAM, 32 KByte nvSRAM, 32MB Flash
• Power monitoring and reset control
• Integrated smartcard reader for standard SIM-cards (hyNet-XS)
• ISDN Interface (NT or TE mode possible).
• USB 1.1 Interface.
• CAN-Bus Interface. (hyNet XS)
• LAN 10BaseT/100BaseT Interface (2x electrical or 2x optical mode).
• Up to 2 serial interface RS232/RS485 fully engaged
• GPS Sync interface for synchronization manners. (hyNet XS)
• IEC1107 interface (3 x). (hyNet XS)
• M-Bus master, separate interface module. (hyNet XS)
• System connectors for additional hardware extensions
• General Purpose input/output pins